Welcome to Shufeng Blower official website!

Language
ChineseChinese EnglishEnglish
Sales Hotline：028-87626039

Chengdu Roots Blower Factory: Several Common Faults of Roots Blower

Category： Company News

time：2022-12-06

　　Chengdu Roots Blower FactoryIntroduce several common faults of Roots blower

1. Corroded and stuck

If the Roots blower is not left idle for a long time, the inside and outside will rust, the large column will fall off on a large scale, and the impeller will be stuck. In this case, use gasoline, diesel engine, and thinner for vehicles. Bubbles and cleaning will rotate. In the case of loose rotation, turn on the switching power supply to operate normally.

2, into the dirty things are stuck

Coarse particles enter the Roots blower to block the gap between the components, causing the Roots blower to not rotate. At this moment, the dirty things need to be carefully taken out to prevent the particles from being broken, and the gap between the impellers should be checked. At the same time, check the main reason for the dirty things to fall into to prevent them from falling into the dirty things again. After the hand rotation is easy, turn on the switch power supply to operate normally.

3. Component deformation

Due to the long-term need, the wet effect of Roots blower components will also cause the deformation of Roots blower components. Of course, this situation is very rare.
 

Understand what details can actually operate Roots blower?

Roots blower, also known as Roots blower, belongs to the capacity rotary blower. It uses three blade motor rotors to make relative movement in the cylinder to reduce and transport gas rotary refrigeration compressors. This kind of blower has compact structure, convenient production and manufacturing, and is suitable for gas transportation and pressure charging in low working pressure places. It can also be used in mechanical pumps.

NextChengdu Roots Blower FactoryXiaobian to introduce to you, the actual operation of Roots blower must master what details:

1. The particle content in the substance cannot exceed 100mg/m³, and the particle size cannot exceed half of the gap in the work.

2. The clearance between the impeller and housing, impeller and baffle plate, impeller and impeller of Roots blower has been adjusted at the factory, and the clearance shall be within a certain range when reassembling.

3. The application of work pressure should not be higher than the scope of pressure specified in the brand.

4. The exhaust temperature of the transportation medium shall not exceed 40°C.

5. When the Roots blower is running, ensure that the grease is in the center of the small red dot on the oil mark. During operation, the bearing temperature cannot exceed 95°C, and the grease ambient temperature does not exceed 65°C.

Methods for Routine Maintenance of Roots Blower

Check whether the anchor bolts in several positions are loose, whether the smooth positions are leaking oil, and whether the bearing temperatures in the two positions are the same. Centrifugal fan enclosures for extreme environments and normal ambient temperatures, these. All kinds of viewing history. Check the smooth and refrigeration system of Roots blower on time, pay attention to the quality of the finishing agent, and listen carefully to the operation of the fan to confirm the operation of the rotor shaft and impeller.

Chengdu Roots Blower Factory: Well, let's talk about it today. If you need to purchase fans, please contact our Chengdu Roots Blower Factory.

 

Keywords： Chengdu Roots Blower Factory: Several Common Faults of Roots Blower

RELATED INFORMATION

Company News

Industry Information

FAQ

Prev： Chengdu Roots blower factory introduces what is the reason for the burning of Roots blower motor?

Next： Characteristics of Sichuan Roots Blower