Welcome to Shufeng Blower official website!

Rotary Blower HC30S

Classification:Rotary fan

(Please click on the picture for parameters) HC30S rotary fan flow rate: 0.36-0.31, pressure: 10-50kpa, motor power: 0.55kw, fan diameter: 25mm. Reference price: 2800 yuan
Product Consulting
Rotary Blower HC30S

Product Details

HC30S rotary blower parameters: HC30S fan

Flow rate: 0.36-0.31, pressure: 10-50kpa, motor power 0.55kw, fan diameter 25mm

 Rotary Blower HC30S

1. Please pay special attention to safety when handling the rotary blower. To avoid the rotary blower from being bruised and impacted, and not to stand up and carry the rotary blower to prevent the lubricating oil from pouring out of the oil tank.

2. Ventilation openings shall be reserved and ventilation fans shall be installed in the fan room. Ventilation openings shall be located in the upper and lower places to facilitate air convection to prevent the normal operation of the rotary blower due to excessive temperature in the machine room.

3. The inner wall of the machine room should be equipped with silencing materials to reduce noise.

4. The rotary blower should be installed horizontally.

5. The diameter of the gas distribution pipe shall not be less than the diameter of the exhaust air of the rotary blower, and the cleaning of the pipe shall be paid attention to. The gas supply pipe shall be installed above the water surface to prevent excessive pressure when starting due to water inflow in the pipe.

6. Be careful not to twist the check valve when taking over (the convex part of the check valve should face up).

7. Please connect the distribution line correctly and pay attention to the marking of the rotation direction of the motor and the rotary blower.

When two rotary blowers are used to run alternately, frequent exchange of starting fans in a short period of time should be avoided. It is hoped that the continuous running time of a rotary blower will not be less than 12 hours.

Test run of (II) and rotary blower

1. Check whether the oil in the oil tank meets the standard (the amount of oil should be higher than the position of the oil outlet).

2. Before starting the rotary blower, please take down the air inlet filter and pour about 30ml of oil into the main engine to make the oil evenly distributed inside the rotary blower (turn it by hand for several times).

3. Check whether the tightness of the V-belt is appropriate. If it is too loose, please adjust it.

4. Check whether the safety valve is set at the specified pressure position, such as the working pressure is 0.3kgf/c ㎡; the opening pressure of the safety valve is 0.3kgf/c ㎡. During the trial operation, you can manually adjust the exhaust valve boost to the opening pressure, adjust the safety valve to make it just open (the pressure is 1.1 times the working pressure).

Keywords:Rotary Blower HC30S

Related Products

Roots blower

Rotary fan

Vortex fan

Stainless steel fan

Product Consulting
Submit Message
message
×